The DKS 6300 Swing Gate Operator is designed for residential, commercial, and industrial applications for both single and dual-leaf gates. The unique design of these operators allows the gate arm to be attached to the bottom rail of the gate. This eliminates the need for any brackets to be welded to the face of the gate and creates an aesthetically pleasing installation.
The DKS 6300 Swing Gate Operator is designed to be pad or post mounted to meet almost any installation requirement. A post or pad mount is required for installation, specify mounting method when ordering.
Standard Features:
Self-adjusting, no maintenance magnetic limits
Overlap feature for dual swing gate operation
Designed with a built-in primary and secondary entrapment prevention system
Ports for plug-in loop detectors
Two convenience outlets
Fail-safe release
Tamper detect circuit
Gate Tracker reporting output provides operator data to access control system* (*DKS systems with card access only)
Programming switches
Built-in reset switch
Built-in power On/Off switch
Class I, II, III and IV applications
Compliant with UL 325 and 991. ETL Listed. (Note: To be compliant with UL 325 and industry safety guidelines, additional secondary entrapment prevention devices may need to be installed with this gate operator.)
Specifications
Operation 1 HP Continuous Duty Motor
Primary Reduction Pulley / Belt Driving a Worm Gear
Power Source 115VAC 60Hz 7.0Amp
Max. Gate Weight 22 Ft. x 800 Lbs
Max. Operating Speed Opens 90 degrees in 16 - 18 Seconds
Max. Duty Cycle 60 Cycles Per Hour / Continuous Duty
Operating Temperature 10 degrees F to 115 degrees F (-12 degrees C to 46 degrees C)
Dimensions 13.25"W x 12"H* x 28"D (Operator Only - Actual Height Determined by Mounting Method)
Warranty 5-Year Limited Factory Warranty