This detector is easy to install and operate. Sensitivity selection is simplified by the ULTRAMETER

The ULTRA-DIN vehicle loop detector combines small size with full-featured functionality in a DIN rail mount module.

SKT-11 socket is a test fixture that mates to vehicle detectors having 11 pin amphenol type connectors.

Lead-in wires terminate in screw terminals

Screw mount (not DIN rail mountable)

The DML-9LP is a plug and play device and requires no settings. It also operates as a low current draw device and runs on 10 to 30 volts AC or DC.

SINGLE CHANNEL, DUAL RELAY OUTPUT.

Standard Features:

• Automatic Tuning
• Lightning & Surge Protection
• Four (4) Frequency Levels
• Compatible with ALL radio controls & remote openers
• Sensitivity Boost
• Fail Safe and Fail Secure Configurations
• Separate Color-Coded LED indicators
• Wide Loop Inductance Range: 20 to 2500 micro Henries

This is only one part of the two part LRS system. Either the LRS-C1 or the LRS-L controller will work with this sensor.

Not recommended for asphalt installations where temperatures exceed 100 degrees.

SINGLE CHANNEL, DUAL RELAY OUTPUT.

Standard Features:

• Automatic Tuning
• Lightning & Surge Protection
• Four (4) Frequency Levels
• Compatible with ALL radio controls & remote openers
• Sensitivity Boost
• Fail Safe and Fail Secure Configurations
• Separate Color-Coded LED indicators
• Wide Loop Inductance Range: 20 to 2500 micro Henries

STANDARD FEATURES

• Automatic Tuning
• Lightning & Surge Protection
• Four (4) Frequency Levels
• Compatible with ALL radio controls & remote openers
• Sensitivity Boost
• Separate Color-Coded LED indicators
• Wide Loop Inductance Range: 20 to 2500 micro Henries
• Velcro pull tab for easy extraction from the rack

Doorking 9411-010 Plug-in Loop Detector - 1 channel + Auxiliary Relay

Doorking 9402-050 Loop Detector Diablo Controls DSP-7 10-30 Volt AC or DC, Solar Friendly

Discontinued by the manufacturer, please use replacement

Reno A & E BX-3 Loop Detector

This is only one part of the two part LRS system. Either the LRS-C1 or the LRS-L controller will work with this sensor.

100% solids and will not “shrink” or “dip” after application, providing an even/flat finished loop and seal. BD-LS can be applied to damp or dry surfaces and provides a superior seal while still allowing movement and elongation should the joint contract or expand.

The NP2-ES’s wide inductance range allows for use with small loops sometimes found in the Parking/Access Control industries

Use this preformed loop in combination with a loop detector to sense when a vehicle is present. This loop can be used to either open the gate or prevent the gate from closing on the vehicle. The GPI Preformed Loop has a 48 foot flexible perimeter and covers driveways up to 30 feet. with a choice of lead-in wire length.

Use this preformed loop in combination with a loop detector to sense when a vehicle is present. This loop can be used to either open the gate or prevent the gate from closing on the vehicle. The GPI Preformed Loop has a 30 foot flexible perimeter and covers driveways up to 21 feet. with a choice of lead-in wire length.